Assembly instructions

1. Turn to the left to loosen and remove the nozzle head.
2. Turn to the left to loosen and remove the nozzle base.
3. Push the nozzle tip out through the front of the nozzle head.
4. Soak the nozzle head, nozzle base and nozzle tip in a 50/50 water-vinegar solution for 3 hours.
5. Assemble the nozzle tip on the nozzle base.
6. Carefully insert the assembly into the nozzle head and turn to the right to tighten.
7. Replace the assembled nozzle head into the nozzle and turn right to tighten.

ATTENTION: Be careful to not tighten the assembly too hard as it might cause permanent damage to the nozzle!